How do I update OmniLogic software?
Press the down arrow at the bottom of the first service mode screen and then select “Upgrade” 6. Select <MSP> from the list of devices and press the checkmark. 8.
How do I connect my Hayward OmniLogic to the Internet?
Press the “wifi bridge” option on the right side of the screen. NOTE: The network password IS CASE SENSITIVE. To confirm connection, go to Config>Network and verify IP addresses appear under the dynamic tab. To change, select the IP address, enter new value, and select check to save.
How do I update my Hayward OmniLogic?
You need to bring the USB memory stick to the OmniLogic and simply plug it into the side of the Local Display behind the Dead Front. Next, you will go into OmniLogic's Configuration Menu and push Firmware Upgrade. The OmniLogic will automatically reboot with the new Firmware.
How do I reset my Hayward OmniLogic?
Shut Down - When Shut Down is selected, the OmniLogic will turn off all pool equipment and report when it is safe to remove power. When this message is displayed, you can either power off the unit or restart the OmniLogic by touching the large power button displayed on the left side of the screen.
How much does Hayward OmniLogic cost?
How Much Does it Cost? Hayward OmniLogic installations can start at $2,800.00 and run upwards of $4,500.00 depending on added accessories.
How do I update my Hayward OmniLogic firmware?
You need to bring the USB memory stick to the OmniLogic and simply plug it into the side of the Local Display behind the Dead Front. Next, you will go into OmniLogic's Configuration Menu and push Firmware Upgrade. The OmniLogic will automatically reboot with the new Firmware.