How do I reset my Prescitech X12 WiFi extender?
Switch the power button “On”& the mode button to “AP” on the side of the extender. Plug the extender into an electrical outlet. The new password should consist of 6-32 characters. Please reset the device if you forget the login password, power on the device, press and hold the reset button on device about 5 seconds.
How do I setup a Prescitech WiFi extender?
- Below setup guide just for Extender Mode by smart phone & WPS method. For AP (Access Point) Mode & troubleshoots, please refer to USER MANUAL. ...
- Power on the X12 next to your Router. Disable your smartphone's own Wi-Fi signal. ...
- Power on the X12 next to your router. Press the WPS button of the front panel on X12.
How do I connect my beta IOT WiFi extender?
Plug the extender into the power outlet near the router, wait for the system light to flash, and start up in about 45 seconds. 2. Open the network settings of the terminal device (mobile phone or computer) and connect to WiFi: On the phone or computer, click Connect and use the wifi named BETA. IOT-XXXX or BETA.
How do I connect to Coredy WiFi?
Connect an Ethernet-Enabled Device
Find and connect to the new extended WiFi network on your computer or WiFi device. The extender creates a new extended WiFi network. The extender's new WiFi network name is “Coredy E300_EXT”, use the same WiFi password that you use for your WiFi router.
How do I reset my Prescitech wifi extender?
Switch the power button “On”& the mode button to “AP” on the side of the extender. Plug the extender into an electrical outlet. The new password should consist of 6-32 characters. Please reset the device if you forget the login password, power on the device, press and hold the reset button on device about 5 seconds.
How do I setup my Prescitech X12 wifi extender?
- Below setup guide just for Extender Mode by smart phone & WPS method. For AP (Access Point) Mode & troubleshoots, please refer to USER MANUAL. ...
- Power on the X12 next to your Router. Disable your smartphone's own Wi-Fi signal. ...
- Power on the X12 next to your router. Press the WPS button of the front panel on X12.