How do I reset my Seagate NAS password?
Power down the NAS device. After about two minutes, power the NAS device on again. Once the drive has restarted, please use your Seagate NAS Discovery software or use the new IP address assigned from your router to access the NAS. The new admin credentials are now reset to their original settings.
How do I access my Seagate NAS?
Access NAS OS using Seagate Network Assistant
- Launch Seagate Network Assistant.
- Choose your device: Windows: Right-click on the Seagate Network Assistant icon in the taskbar to select your Seagate NAS. ...
- Select Web access to the NAS OS.
- The NAS OS login page will launch in an Internet browser.
How do I reset my Seagate Blackarmor NAS 220?
Seagate strongly recommends that you backup all the data from the NAS before continuing.
- Click the Factory Default Restore button to begin the process. A prompt will report, “This restores the device back to factory default settings. ...
- Click Ok. The system will reboot.
How do I reset my Seagate NAS?
Reset using the button
- Power down the Seagate Central by unplugging it from power.
- Wait approximately 15 seconds.
- Power up the Seagate Central again.
- Wait for the device to fully boot and show a steady, non-blinking green light. This takes about three to four minutes. ...
- Wait until the light becomes solidly illuminated.
What is a 192.168 1.2 IP address?
1.2 IP Address. 192.168. 1.2 is a private IP address and is often used as a router IP or default gateway on many routers. So, for example, if the router's settings need to be adjusted, this IP address can get you access to the administrative console and make the necessary changes.
How do I change my 192.168 LL username and password?
TP-Link:
- Login to Router admin panel using its default IP Address – 192.168.0.1 / 192.168.1.1.
- Enter the default username and password (admin/admin in most cases).
- Navigate to Wireless > Wireless Security > WPA/WPA2 – Personal (Recommended) > Password .
- Enter your preferred password and Save the change.
How do I connect to my 192.168 1.1 router?
How to Login 192.168. 1.1?
- Turn on your router and connect it to your computer with an Ethernet cable. ...
- Open your favorite web browser and type “http://192.168.1.1” into the address bar. ...
- Enter the correct router login/password combination.